Pressure transmitters used in the process industries are very durable and reliable instruments. Even so, they still require periodic maintenance and calibration to ensure optimal performance. This is ...

Here at Imaging Resource, a lot rides on our judgement of image quality in the cameras we review, so we pay particular attention to monitor calibration and our viewing environments, to avoid ...

Process instruments consist of two main components: a sensor and a transmitter. The sensor is sometimes part of the instrument assembly, as with some pressure instruments, but is more often separate, ...

This feature helps eliminate the common problem of not allowing enough time for the pH to approach the buffer value that leads to a lower observed slope and higher than necessary slope correction ...

It consistently did a good job calibrating the monitors we tried it with, seemed less prone to getting lost in the weeds with difficult-to-calibrate monitors, and also provides a good capability ...

Expensive spinning lidar units can be found atop and around Level 4 autonomous vehicles, such as those from Cruise and Waymo.

About thirty cents and some wire are all it takes to start hacking extra features into this DX6i transmitter. The DX6i is a six-channel, two-mode transmitter used to control hobby airplanes and ...

Auto-calibration is convenient but less sensitive ... the receiver when you get close to the right breaker. Plug in the ...

Smith] from the University of Washington, which purports to construct a low-throughput RF transmitter from little more than a resistor. This witchcraft is made possible thanks to Johnson noise ...

Typically, RF transmitters that are rated for outdoor use feature a heavy-duty waterproof design. Devices with internal calibration and a frequency range switch are also available.

A software glitch is making NASA’s Voyager 1 spacecraft act a little bit haunted this Halloween season. On October 17, ...

I'm a senior analyst charged with testing and reviewing VPNs and other security apps for PCMag. I grew up in the heart of Silicon Valley and have been involved with technology since the 1990s.